Support |
At 09:11 PM 12/3/98 -0000, Gerry P wrote: >Thanks for the quick response. The MuteMode=continuous didn't solve my >problem completely - in that I still can't get the action of a MUTE press >to >delay to the end of the cycle ( which I had previously) - not immediate - >which the manual indicates is the only way. please check my reply again, looks like you missed the first half of the sentence: "turn quantize parameter on." >I also have a another question > >I use my EDP along with my DAT in my home studio. I would love to have >this >setup in stereo. > >Could I sync the two machines (special cable??), controlling each with >separate foot switches? Is the EDP foot controller of any benefit in >controlling two EDP's. >( vs two EV5's for each) > >For my needs, two EV5 foot switches are all I need for my one EDP. check out the echoplex FAQ on the Looper's Delight page. There is an entire section on stereo echoplexes: http://www.annihilist.com/loop/tools/echoplex/FAQ.html if you still have some question after that, let us know. kim >Thanks in advance >Gerry P >manda@norlink.net >-----Original Message----- >From: Kim Flint <kflint@chromatic.com> >To: Loopers-Delight@annihilist.com <Loopers-Delight@annihilist.com> >Date: Thursday, December 03, 1998 4:08 AM >Subject: Re: Delaying MUTE action? > > >>turn quantize parameter on, MuteMode=continuous. >> >>kim >> >> >>At 09:15 PM 12/2/98 -0000, you wrote: >>>I had my EDP set up so that when I hit MUTE, the loop would continue >playing >>>until the end of the current cycle and then mute - and hitting UNDO, >started >>>the loop from the start - immediately. >>> >>>Last night I was playing with some EDP settings and now I can't get back >to >>>the above. Not only that, but the manual says that MUTE always acts >>>immediately??? >>> >>>Any suggestions would be appreciated. >>> >>>Gerry P >>>manda@norlink.net >>> >>> >>> >>> >>________________________________________________________ >>Kim Flint, MTS 408-752-9284 >>ATI Research kflint@chromatic.com >> >> > > > > ________________________________________________________ Kim Flint, MTS 408-752-9284 ATI Research kflint@chromatic.com