Re: A/B switch for Echoplex

["Scott McGregor Moore" <scott@dreamstate.to>]

For the drilling&soldering types - I'm looking at my EDP footswitch now
and wondering if there might be a suitable taller momentary switch
which could be drilled and mounted above each current switch
with its own jack on the back. Then there'd be 2 independent sets
in the same floorspace. Some paint or electrical tape across that
area (to cover the logos) would keep it from looking too chaotic.
Just a suggestion...

Cheers,
Scott M2

http://www.dreamSTATE.to
ambientelectronicsoundscapes
http://www.THEAMBiENTPiNG.com


> I think I tried it very briefly and it worked, but I ended up returning 
>the
> A/B switch because it was too confusing without some indication of 
>whether
> it was going to A or B. For people who've done this, I'd like
> recommendations on what A/B switches have worked well. (I know. I could
> start drilling holes and making my own footswitch...)
> 
> Mark
> 
> on 8/24/02 10:15 AM, Laurent Brondel at laurentbrondel@earthlink.net 
>wrote:
> 
> > Hello, has anyone tried to control 2 Echoplexes with a single 
>footpedal? I'm
> > trying to use a simple A/B box between a single footpedal and 2 
>echoplexes
> > and only one side seems to be working (A/B box works fine in other
> > contexts). Is there a resistor to place somewhere, ground issues, 
>another
> > solution? I wish to use both echoplexes independently without floor 
>clutter.
> > Thanks!