Support
Looper's Delight
|
Support |
|
|
I don't think so...this is why my new EDPs wouldn't sync right out of the box. Kris -----Original Message----- From: David Kirkdorffer [mailto:vze2ncsr@verizon.net] Sent: Thursday, September 16, 2004 8:43 AM To: Loopers-Delight@loopers-delight.com Subject: Re: Solution for Stereo EDPs and Timing Drift: Three Critical Parameter Settings Kim - The default setting on the Loop IV is Threshold = 0 --- yes? ----- Original Message ----- From: "Kim Flint" <kflint@loopers-delight.com> To: <Loopers-Delight@loopers-delight.com> Sent: Thursday, September 16, 2004 2:06 AM Subject: Re: Solution for Stereo EDPs and Timing Drift: Three Critical Parameter Settings > Hi- > > Just to emphasize since others seem to have this issue: for stereo Echoplex > units, Threshold recording will cause the loops to go out of sync. You need > to set Threshold = 0. > > The threshold parameter sets an audio threshold so that loop recording does > not start until you begin playing. With stereo and threshold on, both units > will begin in a mode waiting for the audio. The audio will always > arrive slightly different between the two units, so it will cross the > threshold at > slightly different times to start the recording. The loops will > therefore usually end up being slightly different lengths, and they > drift out of sync. We tried for some time to think of a way to make > this work but never found it. > > kim > > At 07:26 AM 9/10/2004, Krispen Hartung wrote: > >After struggling with getting my two new EDPs to sync in stereo via > >BrotherSync, Kim Flint came in to save my Friday. My final parameter > >settings are below, and I've noted the setting that did the trick in > >addition to what is recommended in the manual. > > >Threshold=0 (THIRD CRITICAL SETTING, NOT IN MANUAL...NEEDS TO BE SET > >TO 0) > > ______________________________________________________________________ > Kim Flint | Looper's Delight > kflint@loopers-delight.com | http://www.loopers-delight.com >