RE: Solution for Stereo EDPs and Timing Drift: Three Critical Parameter Settings

["Bernhard Wagner" <loopdelightml@nosuch.biz>]

Actually 0 for Threshold is default. When you're in Parameter editing mode
and make a long press on the respective button, you'll jump to the default
setting. Try setting Threshold to 4 or anything, then, without pressing
Parameter button again, make a long press on the MUTE button and Threshold
will jump to 0.
I actually think it would be more useful if the long press wouldn't jump to
the default but rather to the setting the parameter had before you started
changing it. Regularly it happens to me that I navigate to a parameter,
start changing it, realizing only later that it's the wrong parameter, not
remembering what the setting was before I started changing...

Bernhard

> -----Original Message-----
> From: Krispen Hartung [mailto:info@krispenhartung.com]
> Sent: Donnerstag, 16. September 2004 21:20
> To: Loopers-Delight@loopers-delight.com
> Subject: RE: Solution for Stereo EDPs and Timing Drift: Three Critical
> Parameter Settings
>
>
> I don't think so...this is why my new EDPs wouldn't sync right out of
> the box.
>
> Kris
>
>
> -----Original Message-----
> From: David Kirkdorffer [mailto:vze2ncsr@verizon.net]
> Sent: Thursday, September 16, 2004 8:43 AM
> To: Loopers-Delight@loopers-delight.com
> Subject: Re: Solution for Stereo EDPs and Timing Drift: Three Critical
> Parameter Settings
>
>
> Kim -
>
> The default setting on the Loop IV is Threshold = 0 --- yes?
>
>
> ----- Original Message -----
> From: "Kim Flint" <kflint@loopers-delight.com>
> To: <Loopers-Delight@loopers-delight.com>
> Sent: Thursday, September 16, 2004 2:06 AM
> Subject: Re: Solution for Stereo EDPs and Timing Drift: Three Critical
> Parameter Settings
>
>
> > Hi-
> >
> > Just to emphasize since others seem to have this issue: for stereo
> Echoplex
> > units, Threshold recording will cause the loops to go out of sync. You
> need
> > to set Threshold = 0.
> >
> > The threshold parameter sets an audio threshold so that loop recording
> does
> > not start until you begin playing. With stereo and threshold on, both
> units
> > will begin in a mode waiting for the audio. The audio will always
> > arrive slightly different between the two units, so it will cross the
> > threshold
> at
> > slightly different times to start the recording. The loops will
> > therefore usually end up being slightly different lengths, and they
> > drift out of sync. We tried for some time to think of a way to make
> > this work but never found it.
> >
> > kim
> >
> > At 07:26 AM 9/10/2004, Krispen Hartung wrote:
> > >After struggling with getting my two new EDPs to sync in stereo via
> > >BrotherSync, Kim Flint came in to save my Friday. My final parameter
> > >settings are below, and I've noted the setting that did the trick in
> > >addition to what is recommended in the manual.
> >
> > >Threshold=0 (THIRD CRITICAL SETTING, NOT IN MANUAL...NEEDS TO BE SET
> > >TO
> 0)
> >
> > ______________________________________________________________________
> > Kim Flint                     | Looper's Delight
> > kflint@loopers-delight.com    | http://www.loopers-delight.com
> >
>