Re: Programming the Behringer FCB1010 for Echoplex use, a quick guide

["Kris Hartung" <khartung@cableone.net>]

That is true...you can calibrate the FCB pedal for a min and max...it takes
a way to find a good setting for feedback. Basically, I set mine up so  
that
when I pulled the pedal all the way back, the loop fades out to nothing in
about 1 min. In short, I'm using it as a switch to set a fixed feedback
value. For volume, I set the min at 0, however....so I can completely scale
the volume down to nothing.

Kris

----- Original Message ----- 
From: "Travis Hartnett" <travishartnett@gmail.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Sunday, October 30, 2005 9:04 PM
Subject: Fwd: Programming the Behringer FCB1010 for Echoplex use, a quick
guide


I thought you could set the min and max values for the CC pedals for
each patch--I'll check that and report back.  I always wanted an
analog resistor box for feedback with like four settings--100%, 80%,
50% and 25% since those seemed to be the ones I used.

TravisH

On 10/30/05, .David.Auker. <DaVAuk@hevanet.com> wrote:
>
>
> Kris Hartung wrote:
>
> >Now what would be ideal are steps to make exp. pedals A and B control
> >feedback and volume...I did already but forgot how I did it!
> >
> Is there any way for FCB Presets to set Feedback at some precise
> "favorite" levels as the foot rocking on the Expression Pedal is a bit
> of an inexact move (for me, anyway!).   I'm currently doing it with a
> regular expression pedal plugged into the EDP...works fairly well, but
> it gets funky to inadvertently dip down into some low numbers, then
> change, as it makes a "spike."
>
> .David.
>
>