Support
Looper's Delight
|
Support |
|
|
Thanks Dave. I am using the EDP controller, so this is helpful. If it's displaying the current cycle number, can I still overdub? At 4:34 PM -0600 11/24/08, Dave Gallaher wrote: > >On the EDP controller, I sometimes get the same result; the loop will keep >playing, but I can't overdub and cycle numbers appear with each additional >push of Overdub. When this happens, I do one of two things: > >1} finish playing the piece that is using the loop, end by hitting Record, >then hit Undo. Normally, this will return to regular operation, but not >every time. If it fails, then > >2) reboot the EDP. This will restore it to normal record/overdub >operation >in my experience. > >I have not used the function that gives C-1 etc, but it seems to be >counting >cycles when in this mode. Hopefully someone on the list with more >experience with deeper EDP ops can chime in here. > >If you are using the foot controller, I heartily recommend BEFORE YOU >POWER >UP THE EDP, manually tap all the buttons ten or twenty times. I have had >much fewer problems with incorrect response to commands since I started >doing this. DO NOT DO IT WHILE THE EDP IS POWERED UP, OR YOU WILL RESET >YOUR VALUES AND PARAMETERS IN A WAY THAT WILL REQUIRE A FAIRLY LENGTHY >REPROGRAMMING ON THE GIG. Voice of experience... -- David Gans - david@trufun.com or david@gdhour.com Truth and Fun, Inc., 484 Lake Park Ave. #102, Oakland CA 94610-2730 Blog: http://cloudsurfing.gdhour.com Web site: http://www.dgans.com Photos: http://www.flickr.com/photos/dgans Music: http://www.cdbaby.com/all/dgans