Re: Help! FCB1010 is Changing EDP parameters against my will!

[andy butler <akbutler@tiscali.co.uk>]

Jack Schultz wrote:
> Hi All,
> 
>  I'm relatively new here, but I was hoping someone could help me out 
> with my problem.  I programed  my new Behringer FCB1010 to send virtual 
> button, Direct MIDI and continuous controller commands to my Echoplex, 
> but when I use any of the virtual button, or Direct MIDI it resets the 
> parameter settings. For Example,  if I play with Quantize =CYC, 
> Overdub=SUS, and Insert=REV, then after one button press on the FCB1010 
> it reverts to Quantize=OFF, Overdub=EOG, and Insert=rhr.  No matter what 
> my settings were, they alwasys end up the latter. Using the continuous 
> controller to control feed back does not do this, however. 
> 
> I tried repogramming the buttons, but the same thing keeps happening.  
> Does anyone know what causes this 

fcb must be sending PC commands

and how to make it not happen?

de-activate the PC commands from the fcb

> 
> Thanks!
> 
> Jack