Re: Help with Digital Echoplex Pro message

[Tone <tone@nc.rr.com>]

Hey Jeff.

If it's not usable the way it is, you might want to try refreshing to 
factory defaults.  Not sure it's for the exact model you have, but a PDF 
manual that may apply says: "You can reset all parameters to their 
factory defaults by holding down the Parameters button when you power 
up".*  I also looked and found a table of one-digit error codes on p 297 
of the same manual, but they only go up to 6 (checksum error).  
Regardless, when I buy or trade used equipment, I've found resetting to 
factory settings frequently clears up problems if I'm willing to lose 
any settings or clips I have stored.

Regardless, best of luck with your music, as well as your Echoplex

Tony Kane

http://myspace.com/tonecrucible
http://reverbnation.com/tonecrucible


*p 27 of http://www.gibson.com/files/amps/EchoplexPlusManual12.pdf



On 7/26/2013 8:11 PM, JMC wrote:
> My unit powers up fine, shows 198 seconds of time and then displays a number 
> "9"
> in the display window. The feedback light is lit up red but there is no 
> sound recorded or coming out of the output. The unit has been in storage 
> for a couple of years out of use, but I can't find anything in the manual 
> pertaining to this. I also cannot get the parameter button to scroll 
> through any of the options?
>
> Any help would be greatly appreciated!
>
> Cheers!,
>
> Jeff Cloud
> Cloud 9 Recording Studio
> Vista, CA 92084
> 858-699-7441
>
> www.cloud9studio.com
> www.jeffcloud.net
> www.jeffcloudartistry.com