Re: MoFx part 2 (and Repeater midi implementation)

[Mark Sottilaro <sine@zerocrossing.net>]

Nope, what I really need is to be able to put my midi controller into
different "banks" where one pedal can be set to perform different CC#s.  In
other words, in "bank 1" my CC pedal controls pitch shift, in bank 2 it
controls tempo.  I somehow missed the midi loop select up (PC5) and loop 
down
(PC6) which isn't as good as direct loop access, but will do for the 
moment.

Mark

whiteoakstudios wrote:

> If you plug a footswitch into one of the CV inputs of the midi rolls, 
>it'll
> output 0 for off and 127 for on, (or vice versa)
> Is that what you need ?
>
> Gareth
>
> > Yeah, I'm having the same problem you are.  If only the Midiwizard
> > allowed you to associate a CC# and value for a footswitch...  I looked
> > at the Yamaha, but didn't get it as money was tight.  Other than that,
> > the Midiwizard is a fine value.  Seems to me the Repeater's midi
> > implementation could be better.  Does anyone really need to be able to
> > access over a thousand loops from the floor?  With a 128 meg CFC, that
> > would give you about .026 seconds per single track loop.  I think users
> > would be much better served if you could just control 100 or so loops.
> > Still seems like plenty of loops to me.
> >
> > Mark Sottilaro
> >
> > rich wrote:
> >
> > > me again,
> > >
> > > i am currently using a Rolls MidiWizard to control my jamman.  and i
> > > (finally) got the pedal programmed so the controlling switches are
> > > laid out how i want them, rather than dancing all over the place.
> > > thanks to luca for pointers on that from a few months ago...
> > >
> > > now, i'd like to control the mofx from the same pedal board.  on the
> > > Rolls, i can map program changes to different channels, but the mofx
> > > seems to implement a lot of 0-63=off and 64-127=on type commands on
> > > specific control numbers.  The Rolls doesn't seem to be sophisticated
> > > enough to do this (am i correct here?).
> > >
> > > yep, kim, you're right....i need a better midi pedal....but....this
> > > is what i gots for the moment.
> > >
> > > so, my question is: which currently manufactured midi pedal will
> > > allow me to have switches that will turn parameters of the mofx (or
> > > other units....like Repeater, perhaps) on and off with these
> > > controller commands.
> > >
> > > I won't be searching for a pmc-10.  Will the Yamaha MFC-10 do this?
> > > I'm pretty sure the Rocktron All Access will, but that one seems the
> > > priciest of the bunch.
> > >
> > > Anybody have a specific midi pedal hooked up to a MoFx?
> > >
> > > best,
> > >
> > > rich
> >