Re: Sooperlooper or Mobius? Going back to software.

[Jeffrey Larson <jeff@zonemobius.com>]

 > suggested latency is 5 and it reports 256 but when i do calibrate  
latency it shows 360
 > right now i have set to 360 i am going to play for a while with  
that see how it behaves
 > i had tried 256 and even 128 in the past but it felt heavier and  
550 felt allright
 > But lets see how it does with 360
 > thanx!

There are three numbers shown on the calibration results dialog,  
first the
total "end to end" latency from the input port to the output port,  
then suggestions
for the input and output overrides.

The input/output suggestions should be close to half of the total  
latency.  If they
are way off then there may be an error in the calculations.  Try just  
dividing
the total latency by 2 and use that for the input/output overrides.   
If the
total latency was reported as 360 then input/output should both be  
180 which
is pretty good.

Jeff