Support |
Kevin, try this: Give a good smack to the side of your rack, cycle the power, and see if it helps any. I had this same problem for months (usually solved successfully by the aforementioned technique), and it turned out that the RAM and EPROM chips needed to be removed and have their contacts cleaned. I guess that little bit of a jostle must have done just enough to get them working each time. -Hans At 20:21 22/07/2002, you wrote: > I disconnected the EDP from midi, powered up and so far this is what has >happened: > >(Loop 4 zips by three times and then the version # 1.1 shows) x 16 and >counting. I think my EDP is getting sicker... > >kevin > >----- Original Message ----- >From: "Brother Sean" <info@brothersean.com> >To: <Loopers-Delight@loopers-delight.com> >Sent: Monday, July 22, 2002 8:06 PM >Subject: Re: EDP Problem > > > > I tried that, I isolated it from midi but it still did the same thing. >That > > made me really worried... > > > > thanks for your help Kim! > > kevin > > ----- Original Message ----- > > From: "Kim Flint" <kflint@loopers-delight.com> > > To: <Loopers-Delight@loopers-delight.com> > > Sent: Monday, July 22, 2002 5:14 PM > > Subject: Re: EDP Problem > > > > > > > Does it work if you disconnect it from MIDI? Sounds to me like you >might > > > have a midi loop somehow. > > > > > > At 06:00 PM 7/22/2002, Brother Sean wrote: > > > >I have an EDP with Loop IV. I installed the software about a month >ago > > and > > > >everything was working fine but just over the weekend I have had >some > > > >troubles. When I intially power up the EDP will cycle through its >LOOP >4 > > > >screen two to three times before allowing me to enter the actually > > looping > > > >screen (for lack of a better term the screen where your loop time > > appears). > > > > > > we usually call that "reset" when you haven't recorded any loop yet. >Or >we > > > call it the "play state" or "play mode." > > > > > > >It used to never take that long just one cycle through. > > > > > > I'm not sure if I understood exactly what you are seeing, but >normally >the > > > "Loop 4" zips by on the display 3 times at boot up, then stops and >steps > > > off the display, then shows the version, and goes to the reset state. >Are > > > you saying that it is repeating all of this sequence several times? >If >it > > > is repeatedly rebooting itself at power up, there may be some >hardware > > > problem. It could be something simple, like the memory or rom sockets >got > > > dirty or a little corroded. Reseating the roms and the memory might >clear > > > it up. > > > > > > >Also when I press the parameter button in order to modify the >settings >it > > > >won't let me cycle through Timing, Keys, Midi and Loops. It usually >gets > > > >stuck bouncing between Timing and Keys (with each press of the >Parameter > > > >button) and will rarely cycle all the way through allowing me to get >back > > to > > > >the "actual loop screen". I usually just half to shut it down and >power > > back > > > >up. I have tried resetting the EDP by holding down the Parameters >button > > but > > > >that doesn't help. > > > > > > > >It's really strange all this started happening when I was trying to >send > > > >midi CC commands from my Behringer FCB1010 through my MOTU Midi > > Timepiece > > > >II to my Eclipse to change programs up and down. All of my midi >gear is > > > >routed through my Timepiece but it has been setup like this for >almost > > half > > > >a year and no problems. Also my EDP is set to listen to notes and >is on > > Midi > > > >CH#4 and my Eclipse is on Midi CH#5. Are these errors I'm receiving >just > > a > > > >coincidence or do they have a direct correlation to the CC commands >I > > sent > > > >to my Eclipse. Any ideas? > > > > > > If they are really on different channels it should be ok, but your >problem > > > smells a little like a midi loop to me. see if the EDP works when > > > disconnected from the midi stuff and debug from there. > > > > > > kim > > > > > > > > > > > > >______________________________________________________________________ > > > Kim Flint | Looper's Delight > > > kflint@loopers-delight.com | http://www.loopers-delight.com > > > > > > > > > >