Re: Echoloop VST MIDI controller

[paul <phaslem@wightman.ca>]

I hope to have time later today to sit and try and go this again. my 
goal was to have three instances of the plugin, set A to be the 
master and and B and C to sync to it. I did set A as the master and 
then ran a midi link direct to B and C and set them as slaves but the 
loops didn't sync with A so I'm obviously not doing something quite right.

I'll read up on these answers and see if I can get it to work today, 
but you think I need to have midi yoke in there somewhere?

Thanks

Paul Haslem





At 11:06 AM 3/4/2012, you wrote:
> On Sun, Mar 4, 2012 at 4:31 PM, mark francombe <mark@markfrancombe.com> 
> wrote:
> > My questions are so when using 2 instances of the plugin, how is 
> it intended
> > that they sync together?
> > Is it that the midi in goes to the midi in on one plug in then the midi 
> out
> > to the midi in on the second plug.. one set to in, two set to out?
> > or
> > that the midi on goes to both plugs both set to out... or in?
>
>
> Just want to through in an attempt to clear up the thinking here:
>
> A) Either you sync all plugins (including the looper instances) to the
> same tempo source, which i.e. is the host here.
>
> B) Or you sync the looper plugins to each other (first decide on which
> on to be the master).
>
> A or B is it. One would not do both.
>
> Greetings from Sweden
>
> Per Boysen
> www.perboysen.com
> http://www.youtube.com/perboysen